«
»

HP LaserJet 4250 and 4350 Maintenance Kits

By hpmaintenancekit

HP Maintenance Kits for the HP LaserJet 4250 and 4350

You should replace certain parts when the PERFORM PRINTER MAINTENANCE message appears on your printers control panel display. This will help ensure that your printer maintains optimum performance.
The maintenance message will appear every 200,000 pages. The message can be temporarily cleared for approximately 10,000 pages by using the CLEAR MAINTENANCE MESSAGE item on the Resets submenu. To check the number of
pages the printer has printed since new maintenance-kit components were installed, print either a configuration page or a supplies status page.
To print a supplies status page at the control panel

1. Press (SELECT button) to open the menus.
2. Use (UP button) or (DOWN button) to scroll to INFORMATION, and then press
(SELECT button).
3. Use (UP button) or (DOWN button) to scroll to PRINT SUPPLIES STATUS PAGE,
and then press (SELECT button).

To order the printer maintenance kit online follow this link hpmaintenancekits.com
The kit includes:
A new or remanufactured fuser, your choice – reduce costs with a remanufactured assembly
New rollers – a transfer roller, pickup, and feed rollers
Installation instructions
NOTE The printer maintenance kit is a consumable item and is not covered under the original printer warranty or under most extended warranties.
After a maintenance kit is installed, the maintenance-kit counter must be reset.

To reset the maintenance-kit counter
1. Turn the printer power off and then on.
2. When XXX appears on the control-panel display, press and hold down (SELECT
button). Continue holding down (SELECT button) until all three printer control panel
lights flash once, and then stay on. This might take up to 10 seconds.
3. Release (SELECT button) and press (UP button) to scroll to NEW MAINTENANCE KIT.
4. Press (SELECT button) to reset the maintenance-kit counter.
NOTE Perform this procedure only after a maintenance kit has been installed. Do not use this procedure to temporarily clear the PERFORM PRINTER MAINTENANCE message.

Tags: , , , , , , ,

This entry was posted on January 7, 2008 at 4:31 pm and is filed under hp fuser, hp maintenance kit, laser printers, printer repair, technical. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

2 Responses to “HP LaserJet 4250 and 4350 Maintenance Kits”

  1. Hector William Nieto Gomez Says:
    April 3, 2008 at 11:53 pm

    reset de los kit hp. 4200- 4250,4300,4350

  2. Roland Marx Says:
    December 3, 2008 at 11:34 am

    Worked well. Better would be to say when the >>> XXX MB <<< Counter appears, instead of the XXX, desrcibed above. Where X is am Number.

    Thanks very much!

Leave a Reply